I just came into a couple used technos, and Im under the assumption they came from two different owners. One fixture reads V16, and the other reads V226, so in turn im getting some different reactions from the lights even if one is slaved. I tried crossloading one to the othe but I just kept getting a busy signal. Any suggestions on getting this corrected??
I wasnt aware they were different. Macros only affect pan and tilt anyway so...:dunno:
Note that t bird macros from one unit to another dont all do the same thing unles they share the same address. Some macros do all, some do odd, some do even. Check the manual or view it here>> highend.com/pub/products/automated_luminaires/Technobeam/Manual/technobeam.pdf
I wasnt aware they were different. Macros only affect pan and tilt anyway so...:dunno:
Note that t bird macros from one unit to another dont all do the same thing unles they share the same address. Some macros do all, some do odd, some do even. Check the manual or view it here>> highend.com/pub/products/automated_luminaires/Technobeam/Manual/technobeam.pdf
