technobeam error : UPLD

I have tried it several times (more than 10), and are the same model. So this don´t have solution here?

Hey Chris,
What about the "Cheater" button on the PCB, would that help?
Joshua Wood

Gotcha,
I thought I had used it when I was having a problem with uploading software in the past, I must be mistaken...
Or I just happened to get lucky right after doing it.
Josh

Dear Josh, just my 2 cents:

I had the same problem about a year age with a tb from a customer.
Finally it was a loosen connection directly at the cpu. ( If that helps)
Was a bit tricky to find out but it works until now.
I also heard that the ram of the tb can go bad and the result woud be an error you told.

If you have any questions fell free to contact me.:phone:

Best regards from Austria

Roman

if it will let you into the menu system, i'd say go into test and then to boot, to reboot the software. It solves many problems.

We don´t have access to the menu, the UPLD appears at the begining. We have tried to upload with the dongle a new software version but stills the same although the firmware uploads well and the technobeam has a good comunication with the pc (the checksum is ok)

I ran into a problem like this before, and i'm trying to remember what i did to fix it. It was on a color pro.

MAybe throwing them from a 9th floor?:17:

I have a Technobeam with the same problem. Earlier in the year I had this happen & I sent the logic board into Lightparts for repair for them to find nothing wrong with it. So I reinstalled the logic board & it has worked fine till now. Now it just says UPLD again as soon as it's powered on. I don't really want to send it back for repair again just for the same thing to happen & get charged another hundred something dollars for them to find nothing wrong with it. Any ideas?