The 4 dicros on one shaft drive me nuts. Alignment isnt a problem. Use the hole, a no brainer. But the pressure between the 4 units and it's needs to be uniform are a major pain in my ass. :aargh4: It's hit or miss. An ounce too much and the lower wheel wont move, ounce too less and the upper jumps out of sync.:dunno: Theres got to be guidelines in the assembly to make this a bit more accurate. Sometimes I get it right first time. Other times I can spend hours getting it just right. WTF is the deal here?
This has been a piss off point for me for a year now. What do the assembly techs do , use, or know that I need to. :dunce:
:feedback:
