cyberlight

Hi Rafael! There is a sequence that has to followed in order to either shut the lamps off or reset the fixtures. Here it is from the manual:

In order to access the control channel (channel 20 in 20-channel DMX modes 1 and 2 and channel 15 in 15- channel DMX mode 3), you must follow the procedure below:
1. Put the dim channel and the control channel at full.
2. Put the dim channel at zero and the control channel at full.
3. (Must occur within 3 seconds): Put the dim channel at zero. Put the control channel at: 25% for home or 50% for shutdown.
4. Hold for an additional 3 seconds.

Hope this helps. Take care!

Hi Rafael! There is a sequence that has to followed in order to either shut the lamps off or reset the fixtures. Here it is from the manual:

In order to access the control channel (channel 20 in 20-channel DMX modes 1 and 2 and channel 15 in 15- channel DMX mode 3), you must follow the procedure below:
1. Put the dim channel and the control channel at full.
2. Put the dim channel at zero and the control channel at full.
3. (Must occur within 3 seconds): Put the dim channel at zero. Put the control channel at: 25% for home or 50% for shutdown.
4. Hold for an additional 3 seconds.

Hope this helps. Take care!