Cyberlight Strike Problem

Hey Everybody,
I'm a "Cyber Novice", thought I'd get that out there, because maybe I'm just 'missing' something...

I have 11 Cyber CL's, I have this problem with about 5 of them, when I power the fixture, it homes just fine, (and stick it in test mode) it strikes the lamp for about 5-10 seconds, then the lamp goes out, and the Lamp LED just flashes.

I can try turning the fixture on and off again, to "reset" it, and it does the same thing.

Any ideas of what could be wrong?

Thanks,
Caleb
Parents
  • 0
    A few things to check...

    #1 - are your fans all spinning?
    #2 - Since the lamp is firing and then going out it probably is not the ignitor...it sounds like the ballast....if the ballast looks like a piece of toast...it probably is.
    #3 - look at your PSB (power supply board) for any obvious damage.

    go here for all info on Cybers:
    www.highend.com/support/automated_luminaires/cyberlightturbo.asp

    If you click the exploded views link you can see how the fixture is assembled and what parts are where.
Reply
  • 0
    A few things to check...

    #1 - are your fans all spinning?
    #2 - Since the lamp is firing and then going out it probably is not the ignitor...it sounds like the ballast....if the ballast looks like a piece of toast...it probably is.
    #3 - look at your PSB (power supply board) for any obvious damage.

    go here for all info on Cybers:
    www.highend.com/support/automated_luminaires/cyberlightturbo.asp

    If you click the exploded views link you can see how the fixture is assembled and what parts are where.
Children
No Data
Related

www.etcconnect.com