I have an X-spot that refuses to strike. I tried swapping the lamps, the lamp powersupply and the ignitor along with the relay. I swapped all of the parts between two x-spots and the other one fired up just fine with the first ones parts and the first one still wouldnt fire up. I checked the lamp safety switch, it was all good, i also ran a continuity test of the wire loom that goes to the safety switch, and a contiunity test of the wires from the ignitor to the lamp ceramic. ANY IDEAS :aargh4::aargh4::aargh4:
It makes the same striking noise like they normally do. I did swap the relay's when i swapped the ignitor. I'm just running out of things to check. I even swapped the 3 phase pan board thinking it was being weird, but still no change. :mad:
It makes the same striking noise like they normally do. I did swap the relay's when i swapped the ignitor. I'm just running out of things to check. I even swapped the 3 phase pan board thinking it was being weird, but still no change. :mad:
