I have an X-spot that refuses to strike. I tried swapping the lamps, the lamp powersupply and the ignitor along with the relay. I swapped all of the parts between two x-spots and the other one fired up just fine with the first ones parts and the first one still wouldnt fire up. I checked the lamp safety switch, it was all good, i also ran a continuity test of the wire loom that goes to the safety switch, and a contiunity test of the wires from the ignitor to the lamp ceramic. ANY IDEAS :aargh4::aargh4::aargh4:
Damn line filter can cause a no fire also. Bypass it. Also tap in a new lampholder with wire, see if it strikes. If so the wire was shorting to ground somewhere. Thread the wire thru the frame and attach the new lamp holder.
Damn line filter can cause a no fire also. Bypass it. Also tap in a new lampholder with wire, see if it strikes. If so the wire was shorting to ground somewhere. Thread the wire thru the frame and attach the new lamp holder.
