I have a cyber light that i'm recovering from a fire. (stupid breaker in the fixture decided to burn) The fixture fires up fine but when it goes to strike the lamp the lamp ignites but it is very dim (you just see the arc go across the lamp but it isnt bright then it quits, it does this during the strike cycle). I measured 240V on the input card, 240 at the transformer (not the ballast), and 240V at the lamp terminals (the ones on the lps, not the lamp side of the ignitor) during the strike cycle. Any ideas? I cannot remember what the voltage is supposed to be to the ignitor, but i'm thinking its supposed to be between 200-250V.
I always have a spare around to check with. If its toasty you can shake it and hear the stuff inside like sand. I cant recall what it ought to read.:no:
I always have a spare around to check with. If its toasty you can shake it and hear the stuff inside like sand. I cant recall what it ought to read.:no:
