I have a half dozen Intellabeam 700hx and a couple of them are beginning to act a bit strange. They power up fine but a couple intermittantly re-iris, and pan off then return - almost like a rehome without restriking the lamp and rotating the wheels inside. Is this a data board problem? also, occassionally they do not reliably hit programmed cues. The pan/tilt will be off by several degrees consistantly but when re-starting the fixtures they seem to correct. I hope this makes sense. Any ideas would be appreciated. Since these are discontinued, I have one to cannibalize for parts and have done so for some items- mirror.
True that Steve! Theres a small latch in each XLR. Its whats in the hole in the middle of the connector. If it's not in latch position, you can have problems.:blackeye: Is this set-up terminated? Have you put a DMX'ter on the line to check for errors?:dunno: Check for a cold solder joint, and I mean really look close, every wire.
True that Steve! Theres a small latch in each XLR. Its whats in the hole in the middle of the connector. If it's not in latch position, you can have problems.:blackeye: Is this set-up terminated? Have you put a DMX'ter on the line to check for errors?:dunno: Check for a cold solder joint, and I mean really look close, every wire.
