I have a half dozen Intellabeam 700hx and a couple of them are beginning to act a bit strange. They power up fine but a couple intermittantly re-iris, and pan off then return - almost like a rehome without restriking the lamp and rotating the wheels inside. Is this a data board problem? also, occassionally they do not reliably hit programmed cues. The pan/tilt will be off by several degrees consistantly but when re-starting the fixtures they seem to correct. I hope this makes sense. Any ideas would be appreciated. Since these are discontinued, I have one to cannibalize for parts and have done so for some items- mirror.
Thanks for the input. I have checked all the dmx cables, I am using a terminator on the last fixture and I have checked all the solder joints and redone any that seemed in question. Now running the fixture and observing what is happening I am wondering if it is a pan problem. The mirror randomly pans to one side and then returns to its position. It only pans it doesn't home the fixture or tilt. Could this be a pan motor or something on the logic board? I have also tried running this fixture as the 1st in the dmx chain and also last and it makes no difference. Help? :sad:
Thanks for the input. I have checked all the dmx cables, I am using a terminator on the last fixture and I have checked all the solder joints and redone any that seemed in question. Now running the fixture and observing what is happening I am wondering if it is a pan problem. The mirror randomly pans to one side and then returns to its position. It only pans it doesn't home the fixture or tilt. Could this be a pan motor or something on the logic board? I have also tried running this fixture as the 1st in the dmx chain and also last and it makes no difference. Help? :sad:
