I'm working on a status cue system that I'm fixing up before I sell. Anyway I had to piece together a computer with a ISA slot, I did happen across a hard drive with windows 95 (forgot how much of a pain that system was!). So I've got the computer up and running and the software installed and it runs without the link card installed, however when I install the link card it beeps three times over and over (one long beep pause and then two short beeps and repeats) the screen is blank. Oh one other thing thats its doing is the floppy drive is spinning and the busy light is on and there is no disk in it? can anyone help me with this?
With regard to the floppy drive, are you sure the cable is plugged in the right direction? Many times, if the cable is plugged in upside down (easy to do) the drive will act just as you described: the light will remain on even when you have no floppy disk inserted.
With regard to the floppy drive, are you sure the cable is plugged in the right direction? Many times, if the cable is plugged in upside down (easy to do) the drive will act just as you described: the light will remain on even when you have no floppy disk inserted.
