I'm working on a status cue system that I'm fixing up before I sell. Anyway I had to piece together a computer with a ISA slot, I did happen across a hard drive with windows 95 (forgot how much of a pain that system was!). So I've got the computer up and running and the software installed and it runs without the link card installed, however when I install the link card it beeps three times over and over (one long beep pause and then two short beeps and repeats) the screen is blank. Oh one other thing thats its doing is the floppy drive is spinning and the busy light is on and there is no disk in it? can anyone help me with this?
you may be experiencing IRQ conflicts. Until I built up my SQ PC about a year ago, I had forgotten how nice Plug and Play is! Make sure that your link card is set so as not to conflict with any other hardware devices. I don't remember if the memory mapped IO is configurable on the link card, but that may be in conflict too.
you may be experiencing IRQ conflicts. Until I built up my SQ PC about a year ago, I had forgotten how nice Plug and Play is! Make sure that your link card is set so as not to conflict with any other hardware devices. I don't remember if the memory mapped IO is configurable on the link card, but that may be in conflict too.
