Nasty Nasty X Spot

OK Hoping someone has an Idea for me. 1 of our X spots here in OZ 240v at 50hz, The Current Supply in the Factory at testing was 243 Volts.
Ok, the X spot in question runs absolutely fine if it is sat on its base on a case, self test and with DMX Signal.Now for the conundrum.Hang the X spot as it should be off clamps (upside Down), and on start up the following errors imediatly appear in the menu,
Dim2 Sensor Blocked
Dim2 Edge notfound
Cyan Tab not found
CTO tab not found
Color Tab not found
If the unit is sent to self test or DMX signal, these errors are indeed very real and not just a glitch in the screen read out.I have Looked inside nothing appears loose as you may expect from this sort of problem that I can see.:confused:
Somebodys help would be much appreciated, maybe this is one for the High End Boys.

Regards J.P
Parents
  • 0
    Well it just keeps getting better all the Time(HA)
    I tried all of your suggestions, and thought I had it solved, but the problem returned and to compound my problem I was stupidly Unplugging and Plugging the large orange connector on the large Square board at the front of the unit, got it wrong once and now I appear to have nuked that board( 3 phase tilt board I think) as I now have 1 green status light and two flashing red lights resulting in no tilt.(please tell me I have not nuked it but I guess I have).
    any way back to the original problem, it has got worse, sometimes it is ok on start up other times it gets stuck in home, and the aforementioned color wheels just keep spinning round, other times it goes really stupid and the display fritz's also, strobing, small words on top of large words.
    so back to sqaure one.:(
    I also have another X spot that has a pulsating Green Light on the 2 phase board for the litho wheels they are dead in the water, if I fiddle with the board 80060007 near it with the large orange connector marked HD1 it blows the bottom M205 2.5amp fuse. any ideas on that little problem.

    Again any help is much appreciated
Reply
  • 0
    Well it just keeps getting better all the Time(HA)
    I tried all of your suggestions, and thought I had it solved, but the problem returned and to compound my problem I was stupidly Unplugging and Plugging the large orange connector on the large Square board at the front of the unit, got it wrong once and now I appear to have nuked that board( 3 phase tilt board I think) as I now have 1 green status light and two flashing red lights resulting in no tilt.(please tell me I have not nuked it but I guess I have).
    any way back to the original problem, it has got worse, sometimes it is ok on start up other times it gets stuck in home, and the aforementioned color wheels just keep spinning round, other times it goes really stupid and the display fritz's also, strobing, small words on top of large words.
    so back to sqaure one.:(
    I also have another X spot that has a pulsating Green Light on the 2 phase board for the litho wheels they are dead in the water, if I fiddle with the board 80060007 near it with the large orange connector marked HD1 it blows the bottom M205 2.5amp fuse. any ideas on that little problem.

    Again any help is much appreciated
Children
No Data
Related

www.etcconnect.com