I recently replaced the top mirror head(plastic) of a technobeam..reinstalled the cable connections and booted the fixture. The fixture will not home properly and when it is done it read ERR ROT1...the lamp flickers on and off during the process... Any Ideas?
check the leads going to the head, I once slid the sled into the housing and cut the leads and had the same thing with the light flickering(but not lighting). I think one of the cut leads was grounding out.
check the leads going to the head, I once slid the sled into the housing and cut the leads and had the same thing with the light flickering(but not lighting). I think one of the cut leads was grounding out.
