I have a studio spot that the pan feels weak. Such as when it is on its side it will not home correctly, there is very little resistance to move it. The tilt started to act the same way. I tried swapping power supplies thinking it could be weak since it is both pan and tilt. Same results. I tried swapping logic boards (the logic board was marked as good but who knows). Now its just the pan doing it again. Any ideas?
Make sure that there are no broken leads on the motor connectors at either the motor or the logic card. An open phase on a stepper will act this way as well. And an open phase will not affect how the motor feels when you turn it . . .
Make sure that there are no broken leads on the motor connectors at either the motor or the logic card. An open phase on a stepper will act this way as well. And an open phase will not affect how the motor feels when you turn it . . .
