I have a studio spot that the pan feels weak. Such as when it is on its side it will not home correctly, there is very little resistance to move it. The tilt started to act the same way. I tried swapping power supplies thinking it could be weak since it is both pan and tilt. Same results. I tried swapping logic boards (the logic board was marked as good but who knows). Now its just the pan doing it again. Any ideas?
I have checked the leads and made sure that they were plugged in tight. I am having the same problem, it does it only when its panning slowly it begins to drop back down. I guess i will buy a new set of 3 phase chips and give that a try. I guess i will also try swapping motors.
I have checked the leads and made sure that they were plugged in tight. I am having the same problem, it does it only when its panning slowly it begins to drop back down. I guess i will buy a new set of 3 phase chips and give that a try. I guess i will also try swapping motors.
