I have a studio spot that the pan feels weak. Such as when it is on its side it will not home correctly, there is very little resistance to move it. The tilt started to act the same way. I tried swapping power supplies thinking it could be weak since it is both pan and tilt. Same results. I tried swapping logic boards (the logic board was marked as good but who knows). Now its just the pan doing it again. Any ideas?
[quote=TimMiller]should i just pull off the wiring harness on both sides and check with a meter, or i guess i could bring a scope over to the shop and look for the pulses sent to the motor.
I think reading them with a meter would be a good starting point . . .
[quote=TimMiller]should i just pull off the wiring harness on both sides and check with a meter, or i guess i could bring a scope over to the shop and look for the pulses sent to the motor.
I think reading them with a meter would be a good starting point . . .
