I have a studio spot that the pan feels weak. Such as when it is on its side it will not home correctly, there is very little resistance to move it. The tilt started to act the same way. I tried swapping power supplies thinking it could be weak since it is both pan and tilt. Same results. I tried swapping logic boards (the logic board was marked as good but who knows). Now its just the pan doing it again. Any ideas?
ok after lots of frustration, and swapping the logic board, chips, power supplies, and the cable, it came down to the stepper motor. I replaced it and it worked fine. Go figure.
ok after lots of frustration, and swapping the logic board, chips, power supplies, and the cable, it came down to the stepper motor. I replaced it and it worked fine. Go figure.
