Intellabeam DMX channels

[quote=Davyx]Anyway, the installed gobowheel fits to me. For the age of the scanner (mine is from 1990) they are very well designed and still usable. Not like those new fixtures which horrible gobos. They have a modern design, usable for decoration, but not to get any nice beams!
=======
HES makes a custom gobo wheel that is all blanks for the I beam.
Order gobos from Apollo and insert them to get what you want.;)
Metal gobos only.

Thanks for the information!

[quote=Puffyfish]=======
HES makes a custom gobo wheel that is all blanks for the I beam.
Order gobos from Apollo and insert them to get what you want.;)
Metal gobos only.

Any chance you have a part number for that? I have looked in the past, and never saw it on any of thier price lists . . . .

- Tim

I am not sure about the high end wheel,
But here is a link to the apollo wheel.
www.internetapollo.com/Products/View/1785.aspx
Joshua Wood

[quote=Woodj32177]I am not sure about the high end wheel,
But here is a link to the apollo wheel.
www.internetapollo.com/Products/View/1785.aspx
Joshua Wood

Thanks!

- Tim

I know this is a fairly old thread, hoping someone will stumble back across this. I recently got four intellabeam 400s working again. Thanks to this forum I have them all hooked up again however when they are connected and profiled out I get a flashing from them. It is not the iris, intens, color wheel, gobo wheel, or shutter strobe. Have any of you ever heard of this happening?

Does it do that in self test mode as well? The IB 400 was unique in that it dimmed the lamp from 40% to 100% electronically - the full range mechanical dimmer came into being with the 700. Are you also sure that you have firmware that will run DMX, and that you are in a DMX mode? IE personality switch 3 or 4 on *only*?

And you are running the IB400 profile, right? I don't think the 400 ran anything other than 7 (or 8?) channel mode, and if you get that wrong, things will line up oddly. Despite the plethora of old HES docs I have, I can't find a specific mapping for the 400 - just 700, and the later 700's has high res and extended modes that never made it to the 400. In 7/8 channel mode, the dimmer is on channel 6 (at least in the 700) and if you run anything else, then if you have a LSB value on that channel for instance, just about any activity will thrash it.

What console or controller are you using? Since there are no 16 bit channels on a 400, a simple DMX console should make it pretty easy to verify that you are on the right channels.

And if your firmware is ancient, you might only have Lightwave protocol, which will do loads of bizarre stuff . . . but if so, the boards are upgradable . . .

- Tim