X-Spot error codes

First of all I love the display on the X-Spot. Lots of useful information.

The unit I am working on now has several errors.

It has one edge not found error, four tab not found errors, and one closed not found error.

What is the difference between an edge, a tab, and a closed not found error?

I could not find it in the manual.

Also, does this seem indicative of problems with the wheels/sensors or more of a logic board issue?

Thanks

Mike
Parents
  • 0
    I too am curious what specific errors you are getting, but I would guess that most of these errors are likely due to a common two phase card if they all popped up together. What happened that caused this problem? Was anything changed, or did this just show up out of the blue? If a two phase was changed, and the screws put into the wrong holes, it will mis-id the module, which can also manifest itself like this . . .

    Also, when it finishes homing, does it say "X Spot Standard" or something else?

    As Joshua said, give us more info, and I am sure we can help. For that matter, if you have a copy of the manual, it tells you specifically which errors relate to which wheel or component.

    - Tim
Reply
  • 0
    I too am curious what specific errors you are getting, but I would guess that most of these errors are likely due to a common two phase card if they all popped up together. What happened that caused this problem? Was anything changed, or did this just show up out of the blue? If a two phase was changed, and the screws put into the wrong holes, it will mis-id the module, which can also manifest itself like this . . .

    Also, when it finishes homing, does it say "X Spot Standard" or something else?

    As Joshua said, give us more info, and I am sure we can help. For that matter, if you have a copy of the manual, it tells you specifically which errors relate to which wheel or component.

    - Tim
Children
No Data
Related

www.etcconnect.com