X-Spot error codes

First of all I love the display on the X-Spot. Lots of useful information.

The unit I am working on now has several errors.

It has one edge not found error, four tab not found errors, and one closed not found error.

What is the difference between an edge, a tab, and a closed not found error?

I could not find it in the manual.

Also, does this seem indicative of problems with the wheels/sensors or more of a logic board issue?

Thanks

Mike
Parents
  • 0
    Ok,
    Focus edge not found,
    one of the focus sensor is not reading,
    While the fixture is homing, does the gobo/iris sled move up and down?
    If not one of the focus motors has probably failed.
    CTO Tab not found
    CTO is not homing, and since the other 2 wheels that use that sensor are fine, the motor has probably failed.
    Rot 1 tab not found,
    The gobo 1 rotate sensor has either failed, or the motor has failed, thus the tab not being found.
    Does the gobo 1 rotate motor turn while homing? (wheel closest to the lamp)

    Rot E tab not found,
    I believe this is the effect wheel, (2nd from the lamp)
    and it also is not finding the rotate sensor,
    does the rotate motor turn during homing?

    Good Luck!
    Joshua Wood
Reply
  • 0
    Ok,
    Focus edge not found,
    one of the focus sensor is not reading,
    While the fixture is homing, does the gobo/iris sled move up and down?
    If not one of the focus motors has probably failed.
    CTO Tab not found
    CTO is not homing, and since the other 2 wheels that use that sensor are fine, the motor has probably failed.
    Rot 1 tab not found,
    The gobo 1 rotate sensor has either failed, or the motor has failed, thus the tab not being found.
    Does the gobo 1 rotate motor turn while homing? (wheel closest to the lamp)

    Rot E tab not found,
    I believe this is the effect wheel, (2nd from the lamp)
    and it also is not finding the rotate sensor,
    does the rotate motor turn during homing?

    Good Luck!
    Joshua Wood
Children
No Data
Related

www.etcconnect.com