Is there any documentation that would assists in cleaning our Studio Commands? If not, any suggestions or recommendations would be appreciated. Thanks...
Yea, I asked about that at high end training, And it was suggested that we don't dissassemble them. that module is pretty complicated, with loads of spacers. It of course is possible, but I don't know of any documentation on a specific way to dissassemble the modules. If you go for it, Be very careful, and make sure you know exactly where every spacer goes, Many of them are different. Good Luck!
Yea, I asked about that at high end training, And it was suggested that we don't dissassemble them. that module is pretty complicated, with loads of spacers. It of course is possible, but I don't know of any documentation on a specific way to dissassemble the modules. If you go for it, Be very careful, and make sure you know exactly where every spacer goes, Many of them are different. Good Luck!
