I'm working on a cyberlight cl and when I opened it up to set the voltage I found what I would say looks to be some kind of bypass? I've seen and done the trackspot voltage select bybass, I did a search on this fourm and did not come across anything. I do not want to plug it in for fear of frying something! The white tap wire is butt conected to a black wire?(see attached pic)If I cut out the butt cont. what do I do with the blk wire? BTW I want to tap it for 230v 60Hz, I did read some post on this forum about some people being tapped at 230v and pluging into 208V, I am worried the if it's tapped at 208 and I plug into 230 that cause I'm going from a lower to higher voltage it might blow the damm thing up!!
Ok I think I have an idea about what is what, now I need the why? I looked and noticed below the voltage tap another set of blade conectors on the board and one wire missing labled blk, so I now know where the black wire went. So it looks like it is a bypass, and I'm stuck wondering WHY? Is there something wrong with the board? And if so can I do the same bypass for 230v, and what color wire would I use? and do I need to hook the black back up? I need this fixture for an install next week so I really don't want to fry anything!
Ok I think I have an idea about what is what, now I need the why? I looked and noticed below the voltage tap another set of blade conectors on the board and one wire missing labled blk, so I now know where the black wire went. So it looks like it is a bypass, and I'm stuck wondering WHY? Is there something wrong with the board? And if so can I do the same bypass for 230v, and what color wire would I use? and do I need to hook the black back up? I need this fixture for an install next week so I really don't want to fry anything!
