I would like to know how to calibrate and/or adjust the mirror so it will index properly. It goes past its pan limit then pops to center. THANK YOU FOR YOUR SUPPORT
Replace / tighten the plunger that pushes against the shaft (or in the case you have a really old one or new one I forget the order) then replace the motor break... It could also be the stepper motor, driver, or wire / harness. More than likely in that order ;-)
Replace / tighten the plunger that pushes against the shaft (or in the case you have a really old one or new one I forget the order) then replace the motor break... It could also be the stepper motor, driver, or wire / harness. More than likely in that order ;-)
