Hello All:
It's been a while since I've ventured into these forums!
I'm having some rather odd problems with Cyberlights, there is one in my rig (and by one I don't mean one specific unit, it seems to be the same one every time, no matter if we swap the Cyber itself or not) that is both sending and feeding back corrupted data.
There are 2 MAC 2000s and 2 VL3000 one before and one after the Cyber each. The VLs seem to just freeze or freak out when the Cyber is turned on. I had low voltage going to them which we've fixed, and yet they seem to be doing it again. Could this by any means be related to bad DMX off the source? Or should I maybe look at voltage issues again? I beleive we're about 206V to the unit, which is tapped to 208V.
I've replaced the Cyber 3 times, and already tried out 4 DMX cards, so its deffinitely not that one light, but something related to the configuration, I have other setups like that along the rig, and I've seent his crop up somewhere else, but nowhere as bad as this one.
Any ideas?
Cheers!
