Xspot n1/n2/n3 problem??

Hey guys,
Im not quite sure what has happened to 2 of my 9 xspots in my rig, but they are now displaying 'N1/N2/N3' instead of 'STANDARD' like the rest of them, and i cant seem to figure out what has happened. I can control the fixtures and strike the lamps, but just no output on stage. I checked the other 7 and noticed they all flash the word 'standard' and these 2 that are the issue aren't displaying that.
Any thoughts??

THanks in advance!!

Mikey

Parents

0 woodj32177 - Former HES Forum Member over 14 years ago

I would check the fuses in the base,
1 of them powers all the 2 phase cards.
perhaps it has blown. in which case it might throw that error.
Make sure you remove the fuses to meter them, as they will still ring out if they are in place, even if they are bad.
Good Luck,
Joshua Wood
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 woodj32177 - Former HES Forum Member over 14 years ago

I would check the fuses in the base,
1 of them powers all the 2 phase cards.
perhaps it has blown. in which case it might throw that error.
Make sure you remove the fuses to meter them, as they will still ring out if they are in place, even if they are bad.
Good Luck,
Joshua Wood
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data