Studio Spot Error Code

Hi there,
one of my studio spot 575's is showing an error code which isn't shown in the manual, namely:
CLR1 or possibly CLRI

It flashes HOME - CLR1 - Err
then points towards the ballast after striking up.
Obviously this is a colour error, however colour wheel 1 tests fine, whereas colour wheel 2 appears stuck between two frames.
Any advice or suggestions?

Parents

0 marty postma - Former HES Forum Member over 15 years ago

Probably a bad or dirty sensor. Try cleaning the sensor.

You can also verify this by swapping the these two sensor plugs @ the logic board....if the problem moves over to the other wheel after the swap, then you know where your issue is.

Hope this helps. :)
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 marty postma - Former HES Forum Member over 15 years ago

Probably a bad or dirty sensor. Try cleaning the sensor.

You can also verify this by swapping the these two sensor plugs @ the logic board....if the problem moves over to the other wheel after the swap, then you know where your issue is.

Hope this helps. :)
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data