• State Not Answered
  • Date
    stephenwyker
  • Date
  • Replies 5 replies
  • Subscribers 13 subscribers
  • Views 606 views
  • Users 0 members are here

x.spot cmy color speed adjustment

I'm trying to figure out how to STOP the fixtures from decideding by themselves whether to fade from 0>100 to take the shortest trip (thus going from fully saturated to nothing and showing the "line") -- is this something within HOG3 or the menu? Of 4 fixtures, I do a rainbow, speed it to 25 per minute and 2 of the 4 take the shortest trip. I see something in the manual about continuous vs pure mix ... but i can't find in H3 how to change it.

All are using 4.1.5 software. It's REALLY annoying. I really don't care either way which it decides to do, I just want them all to do the SAME thing. Is it a fixture issue, programming issue, combination of the 2? I understand that i'm trying to make it go faster than the fixture can "go" but it should just cut the top and bottom of the sine then right?
Parents
  • 0
    If all fixtures are patched using the same library and you tell all fixtures to do the same thing and some of them do while others do something else that would suggest the main issue is to do with fixture configuration/setup.

    As far as I'm aware the difference between continuous and pure mix modes is very subtle. Basically one of them goes from open - full saturation while the other is open - full saturation - open.

    Thanks,

    Steve
Reply
  • 0
    If all fixtures are patched using the same library and you tell all fixtures to do the same thing and some of them do while others do something else that would suggest the main issue is to do with fixture configuration/setup.

    As far as I'm aware the difference between continuous and pure mix modes is very subtle. Basically one of them goes from open - full saturation while the other is open - full saturation - open.

    Thanks,

    Steve
Children
No Data
Related

www.etcconnect.com