I have a cyber hanging in a club that has been giving me what seems to be a common issue, it would boot up then run fine for a while then...... the bulb would go out and it would stop responding to dmx, then after 10 mins or so power down. Sometimes it was down for the night sometimes after a few mins it would reboot and run again, sometimes only for a few mins and other times for hours. Hell some nights it ran all night like a champ!! I've read all the post on here that seem to apply, and here is what I've done so far:
swapped out the 14 pin harness a few times--same
swapped out logic board a few times --- same
and yes the xlr connectors are locked
and today I pulled the power board resoldered the contacts, the reason for this is that if you bang on the light it starts back up making me think it's not a electric prob but something physical like a cold solder joint or component on the board. When I put it back in and everything worked fine....... however I do notice that one fan was not spinnig(one of the bottom ones) the light ran for about an hour when I noticed the lamp was out, it was running dmx fine. I was even able to re strike the lamp from the board, so I'm thinking it overheated. So I powered it off and back on, now here where I am lost? The all fans runs when the power is frist turned on it starts to home, stops for a sec the one fan then stops and it finishes homing and runs?
