Trackspot Gobo fault

Hi, I'm used to the mirror giving the sensor fault noise and am slowly replacing all the sensors but one is giving a beeping noise form the gobo stepper. What does this mean and is there any document that gives all the fault codes and service methods (like homing and realigning steppers?

Many thanks.
Matt Poole.

Parents

0 bigdarkspot - Former HES Forum Member over 12 years ago

I've never heard the fault noise come from anything but the mirror. It's possible that the logic network driving the 'Enable' pins on the 8-bit latches that drive the motor chip has a fault in it, causing it to respond to the wrong data bits on the data bus. It's also possible that I just never noticed the wheels makiing the fault sound, since the mirror is louder.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 bigdarkspot - Former HES Forum Member over 12 years ago

I've never heard the fault noise come from anything but the mirror. It's possible that the logic network driving the 'Enable' pins on the 8-bit latches that drive the motor chip has a fault in it, causing it to respond to the wrong data bits on the data bus. It's also possible that I just never noticed the wheels makiing the fault sound, since the mirror is louder.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data