SS 575... When I turn it on, it does the LWR on the panel, does the self diagnostic stuff, but then when it comes time to home the fixture, it resets, and starts the boot process again...
Has anyone seen this before, and is it an easy fix?
oh.. one more test.. .disconnected the tilt motor, did the test... It went all the way through the homing process, then when it went to swing the pan motor to the home position, the brain reset itself, and did the homing process again. so, I swapped tilt motors, turned it on, and it went back to it's old tricks.
so I disconnected the pan motor, and did the same test... it went thiugh the process, but, not after not finding the pan motor, it reset itself a minute after the homing process.
screw it- I'm putting that brain into a different fixture :)
oh.. one more test.. .disconnected the tilt motor, did the test... It went all the way through the homing process, then when it went to swing the pan motor to the home position, the brain reset itself, and did the homing process again. so, I swapped tilt motors, turned it on, and it went back to it's old tricks.
so I disconnected the pan motor, and did the same test... it went thiugh the process, but, not after not finding the pan motor, it reset itself a minute after the homing process.
screw it- I'm putting that brain into a different fixture :)
