I have a SolaFrame Theater fixture that does not boot up. It shows on the screen the logo and says "Boot v. 1.1.4" and "Data check". It attempst to start up its internal checks and does the shutters and maybe one of the lenses. But it never goes past maybe 4 sec of these checks and the screen never progresses. I pushed the firmware to it again, which is actually higher number than 1.1.4. Firmware loader says success, however the fixture still does not boot up. There are no errors shown as the screen is stuck in that initial boot. I suspect the main display logic board has gone bad? Is that the correct route to go on troubleshooting?