Controlling a DL1 with a JANDS 416

Hi all
This might be a bit old school but I was wondering if I can control a DL1 with a JANDS 416 and if so are there any limitations. Thanks in advance
Parents
  • Any edge blending is going to be dependent on the media server or content source used to feed the DL.1 fixtures. The DL.1 does not have a media server on-board.

    It sounds like you may be needing to take a look at the the DL.2 or DL.3, unless you are driving the DL.1 with external media servers.

    Have a look at the Collage Generator Information at the link below. But again, these are for DL.2 or DL.3 only.

    www.highend.com/support/digital_lighting/dl2supportguide/dl2-collage.asp

    Hope this helps,
    p
Reply
  • Any edge blending is going to be dependent on the media server or content source used to feed the DL.1 fixtures. The DL.1 does not have a media server on-board.

    It sounds like you may be needing to take a look at the the DL.2 or DL.3, unless you are driving the DL.1 with external media servers.

    Have a look at the Collage Generator Information at the link below. But again, these are for DL.2 or DL.3 only.

    www.highend.com/support/digital_lighting/dl2supportguide/dl2-collage.asp

    Hope this helps,
    p
Children
No Data