• State Not Answered
  • Date
    jeffm - Former HES Forum Member
  • Date
  • Replies 15 replies
  • Subscribers 7 subscribers
  • Views 3340 views
  • Users 0 members are here
Options
Related

collage access.

Your instructions posted on the websight talk about GLobal modifier 1 needing to be at a DMX value of 134 to access the collage function. Then says Modifier 1 at a value of 1 to set up the configuration I am using.
The language your using on the websight doesn't compute to what my Hog II PC stage output says.
Can you put the instructions in the form relating to what the output parameters say on them. Otherwise I am going in circles and getting knowhere.
The parameters on the global section are as follows:
cyan/magenta/yellow/Fx1/Fx2/Fx2m1/Fx2m2/Fx2m3/masksel/masksize/
maskfade/fadetop/faderght/fadebot/fadeleft/keyx1/keyy1/keyx2/keyy2/
keyx3/keyy3/keyx4/keyy4/keyxrat/keyyrat/viewmode/viewxpos/viewypos/
viewzpos/ctrlmode/ctrlvalu/
I need to know if Fx2m1 is modifier 1 ect...
Do you have any conversion charts that convert the language for us lighting /non video guys?
Parents
  • 0
    The modifiers for Effects #1 (Fx1) are Cyan-Magenta-Yellow
    The modifiers for Effects #2 (Fx2) are Fxm1-Fxm2-Fxm3
    ;)

    A quick study of the DL-2 DMX chart should reveal this:
    www.highend.com/pub/products/digital_lighting/dl2/docs/DMX_Protocol.pdf

    The chart is also available in the manual included in the CMA software

    You might do well to convert to Hog-3PC, b/c if you are programming DL-2s on the old H2 platform I feel for you!:aiwebs_007:

    Not that I don't have love for H2 (I worked on them for almost 10 years), but H3 just makes so much more sense when you start getting involved with these things. It's a bit like trying to run large numbers of moving lights off of say an ETC board....yes you can, but WHY put yourself through that?!?:hogsign:

    At any rate I hope the info is helpful:)
Reply
  • 0
    The modifiers for Effects #1 (Fx1) are Cyan-Magenta-Yellow
    The modifiers for Effects #2 (Fx2) are Fxm1-Fxm2-Fxm3
    ;)

    A quick study of the DL-2 DMX chart should reveal this:
    www.highend.com/pub/products/digital_lighting/dl2/docs/DMX_Protocol.pdf

    The chart is also available in the manual included in the CMA software

    You might do well to convert to Hog-3PC, b/c if you are programming DL-2s on the old H2 platform I feel for you!:aiwebs_007:

    Not that I don't have love for H2 (I worked on them for almost 10 years), but H3 just makes so much more sense when you start getting involved with these things. It's a bit like trying to run large numbers of moving lights off of say an ETC board....yes you can, but WHY put yourself through that?!?:hogsign:

    At any rate I hope the info is helpful:)
Children
No Data

www.etcconnect.com