• State Not Answered
  • Date
    jeffm - Former HES Forum Member
  • Date
  • Replies 15 replies
  • Subscribers 7 subscribers
  • Views 3454 views
  • Users 0 members are here
Options
Related

collage access.

Your instructions posted on the websight talk about GLobal modifier 1 needing to be at a DMX value of 134 to access the collage function. Then says Modifier 1 at a value of 1 to set up the configuration I am using.
The language your using on the websight doesn't compute to what my Hog II PC stage output says.
Can you put the instructions in the form relating to what the output parameters say on them. Otherwise I am going in circles and getting knowhere.
The parameters on the global section are as follows:
cyan/magenta/yellow/Fx1/Fx2/Fx2m1/Fx2m2/Fx2m3/masksel/masksize/
maskfade/fadetop/faderght/fadebot/fadeleft/keyx1/keyy1/keyx2/keyy2/
keyx3/keyy3/keyx4/keyy4/keyxrat/keyyrat/viewmode/viewxpos/viewypos/
viewzpos/ctrlmode/ctrlvalu/
I need to know if Fx2m1 is modifier 1 ect...
Do you have any conversion charts that convert the language for us lighting /non video guys?
Parents
  • 0
    thanks for the help. I had to rebuild the patch with the new library, then merge my show into this new one. The collage generation works great.
    The only thing I see wrong is with the intructions and the parameter layout for H2PC. The color wheels do the Modifiers and the FX1 does the collage. Yellow picks what part of the grapgic to project and cyan picks the grid setup for the number of fixture you have.
    Too bad the instructions couldn't be written in these simple terms for all to understand.
    So here is is again for those who don't speak video.
    the Parameter Fx1 goes to full which is labeled collage.
    then cyan goes to level 1 in my case for 2 fixtures side by side
    and yellow selects which part of the graphic each fixture will be projecting.
    a good starting point is to select a grid on the yellow wheel to help alignment first.
    Jeff
Reply
  • 0
    thanks for the help. I had to rebuild the patch with the new library, then merge my show into this new one. The collage generation works great.
    The only thing I see wrong is with the intructions and the parameter layout for H2PC. The color wheels do the Modifiers and the FX1 does the collage. Yellow picks what part of the grapgic to project and cyan picks the grid setup for the number of fixture you have.
    Too bad the instructions couldn't be written in these simple terms for all to understand.
    So here is is again for those who don't speak video.
    the Parameter Fx1 goes to full which is labeled collage.
    then cyan goes to level 1 in my case for 2 fixtures side by side
    and yellow selects which part of the graphic each fixture will be projecting.
    a good starting point is to select a grid on the yellow wheel to help alignment first.
    Jeff
Children
No Data

www.etcconnect.com