• State Not Answered
  • Date
    sblair - Former HES Forum Member
  • Date
  • Replies 23 replies
  • Subscribers 7 subscribers
  • Views 1684 views
  • Users 0 members are here
Options
Related

DL.2 v1.3.2 Released!

We have just released verion 1.3.2 of the DL.2 Software today.

This version adds a number of new effects and improvements to the software.

The Press Release for information about new features in this software are located at: www.highend.com/news_events/news/news_detail.asp?news_id=379

The full Release Notes and Software are available at: www.highend.com/support/digital_lighting/DL2andAxonSoftwareUpgrades.asp
Parents
  • 0
    Marty,
    Thanks for your response. Some answers to your questions
    We are using a Gigabit switch with the CMA. Also we are using Belden 7924A Cable in which we have fabricated for use with these units.
    We have also ran into another issue specific to this fixture. We have had no problems with the other unit.
    This same unit in which we had the problem uploading the new software with also will not totally come online on power up.
    Upon boot up the display indicates the High End Logo and then goes blank. We only have control of pan and tilt but cannot access the graphics engine.
    The units were hung from a truss in the shop for programming. We ended up taking the unit down and flipping over on it's base. We now have control of the unit. We powered down the unit once again and now have the same problem in reverse. Checked all our settings in the CMA for display flip ect.
    (all settings are the same between the 2 units on the CMA, only this one unit is giving us fits) Any suggestions on a course of action we can take before opening the unit? Heading back to the shop to see how things are progressing with the programmer and if they have any other issues after the weekend.
    Thanks
Reply
  • 0
    Marty,
    Thanks for your response. Some answers to your questions
    We are using a Gigabit switch with the CMA. Also we are using Belden 7924A Cable in which we have fabricated for use with these units.
    We have also ran into another issue specific to this fixture. We have had no problems with the other unit.
    This same unit in which we had the problem uploading the new software with also will not totally come online on power up.
    Upon boot up the display indicates the High End Logo and then goes blank. We only have control of pan and tilt but cannot access the graphics engine.
    The units were hung from a truss in the shop for programming. We ended up taking the unit down and flipping over on it's base. We now have control of the unit. We powered down the unit once again and now have the same problem in reverse. Checked all our settings in the CMA for display flip ect.
    (all settings are the same between the 2 units on the CMA, only this one unit is giving us fits) Any suggestions on a course of action we can take before opening the unit? Heading back to the shop to see how things are progressing with the programmer and if they have any other issues after the weekend.
    Thanks
Children
No Data

www.etcconnect.com