Options
Related

preparing footage for DL.3

I am trying to figure out how to prepare footage for 5 DL.3´s in combustion, to create one image...is it possible to feed the server with an Image (mpg2) with this measurements: 5120 x 768 or do I have to split up the clip first and put it together on server side?

cheers

Benno
Parents
  • 0
    Not all that sure, I use TMPEG personally, but I know that Episode can also do the job.

    As long as you follow the guidelines you'll be fine:

    1 - All I-Frames ONLY in GOP (no P's or B's)
    2 - Elementary Stream (not System Stream)
    3 - Set bitrate to be Constant @ 20,000,000 bps (no variable rates!)
    4 - No audio
    5 - Use only 4:2:0 colorspace
    6 - progressive only (not interlaced)
    7 - check frame rate (29.97 is most common)
    8 - Pixel size not to exceed 800,000 (multiply width by height)

    All of these are important, if you cannot meet one of these requirements specifically it could mean the difference between your file working or causing the whole server to lock up.

    Hope this helps :)
Reply
  • 0
    Not all that sure, I use TMPEG personally, but I know that Episode can also do the job.

    As long as you follow the guidelines you'll be fine:

    1 - All I-Frames ONLY in GOP (no P's or B's)
    2 - Elementary Stream (not System Stream)
    3 - Set bitrate to be Constant @ 20,000,000 bps (no variable rates!)
    4 - No audio
    5 - Use only 4:2:0 colorspace
    6 - progressive only (not interlaced)
    7 - check frame rate (29.97 is most common)
    8 - Pixel size not to exceed 800,000 (multiply width by height)

    All of these are important, if you cannot meet one of these requirements specifically it could mean the difference between your file working or causing the whole server to lock up.

    Hope this helps :)
Children
No Data

www.etcconnect.com