Options
Related

CMA Issues

CMA is stable *finally, and one fixture is working fine. The new issue is the other DL2 lets me think I can load a file into a folder but nothing shows up. Heres what happens: shows a progress bar, but then nothing is in a folder. I can add a folder, but does not upload anything to it. Have tried diffrent content, different folders, adding content to other DL2 *works, and deleting and adding, no luck adding.

I have the most current Firmware and CMA.

Any help?

Edward

Edward Hodge
Entertainment Technology Consulting - Lighting Design -
Technical Director - Video Design
TEA - Themed Entertainment Association BOARD MEMBER
2009 Emmy Nomination *(Special Television Event) with CBS
Parents
  • 0
    Marty can probably explain this better but
    to get you started.
    You need.
    1.A copy of the latest DL2 software downloaded
    and burnt as an ISO disc using the
    correct software.This is available from here
    www.highend.com/support/digital_lighting/DL2andAxonSoftwareUpgrades.asp
    2.An external USB keyboard
    3.An external CD drive with mains supply.

    To start doing this with the fixture on the
    ground or somewhere with good access is a must.
    You may want the manual to hand
    www.highend.com/support/digital_lighting/dl2.asp

    Use the iso disc you have burnt to reinstall
    or install the latest xpe image on the fixture.

    I'll let marty explain the rest better than I can,
    one tip on the older DL2 fixtures you can
    only get the iso to boot by pressing tab
    on the keyboard directly after the spinning

    high end splash screen comes up on the fixture
    screen so be ready !

    best of luck
    miss that
Reply
  • 0
    Marty can probably explain this better but
    to get you started.
    You need.
    1.A copy of the latest DL2 software downloaded
    and burnt as an ISO disc using the
    correct software.This is available from here
    www.highend.com/support/digital_lighting/DL2andAxonSoftwareUpgrades.asp
    2.An external USB keyboard
    3.An external CD drive with mains supply.

    To start doing this with the fixture on the
    ground or somewhere with good access is a must.
    You may want the manual to hand
    www.highend.com/support/digital_lighting/dl2.asp

    Use the iso disc you have burnt to reinstall
    or install the latest xpe image on the fixture.

    I'll let marty explain the rest better than I can,
    one tip on the older DL2 fixtures you can
    only get the iso to boot by pressing tab
    on the keyboard directly after the spinning

    high end splash screen comes up on the fixture
    screen so be ready !

    best of luck
    miss that
Children
No Data

www.etcconnect.com