I have 4 DL2's on a rental. They are all the same software version as I did preprogramming at the shop a couple of weeks ago. I am running them in Artnet mode being supplied by a DP8000.
Now, here's the oddity. All 4 units perform perfectly in Artnet mode (whcih means there is communication). However, when I turn on CMA (on both my laptop and the Axon), I only see 1 DL2. :dunce:
I don't run CMA while running the show (and all of the artnet traffic), but would like to deploy some additional content. Is there any reason known to man that I could talk on Artnet, but not see the fixtures on the CMA?
