P/T accuracy

I'm sure this has been discussed before, but how does one deal with a college and repeatability? I was to do a 2x6 college (which looked great) but then the client also wanted another look around the room for opening. I didn't think about it until rehearsal and clicked back to the college and all the alignment was off. Not by a lot, but enough that the college couldn't work.

Thought it was my programming, updated and tried again and same situation. Any good advise (besides not moving them)

Parents

0 abbe rpm digital lighting - Former HES Forum Member over 13 years ago

Hi,

Now i do program mostly DML-1200 but a lot with Collage and my experience is that when i have this problem i replace all position information as hard values and NONE in pallets.
Now you could say that this should not matter but i find that the workmethod supports the hysteresis of the fixture, forcing a return from the same direction every time for the new position.

Can you still try this? Or is the event over?

I do not think there is anything wrong with the fixtures.

I hope it works out.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 abbe rpm digital lighting - Former HES Forum Member over 13 years ago

Hi,

Now i do program mostly DML-1200 but a lot with Collage and my experience is that when i have this problem i replace all position information as hard values and NONE in pallets.
Now you could say that this should not matter but i find that the workmethod supports the hysteresis of the fixture, forcing a return from the same direction every time for the new position.

Can you still try this? Or is the event over?

I do not think there is anything wrong with the fixtures.

I hope it works out.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data