Syncing DL.3 Times

I'm having an issue with a group of DL.3's I'm using for a project. 4 units, 2 are brand new, and 2 are 2 years old. I make a 2x2 college, and over time, the video timing skews. Fixture 1 is my upper left corner fixture (and the oldest) -- I have no sync to or sync type. On fixtures 2>4, I have sync to (1) and sync type graphic 1.

Why is the issue still happening? Network cables are attached and all fixtures are seen in CMA. Newest software release. Hog III, 3.1.9. Unmanaged network switch between them.
Parents
  • Here is a post that has some relevant information.
    forums.highend.com/showthread.php?t=11647&highlight=sync+DL3

    Do your fixtures have different fixture id's?

    Having a setup que as described has always been helpful in keeping fixtures in sync.
    My menthod is tho have the relevant layers at 0 intentsity,and rewound in the mode settings in que 1 and then loop forward at full intensity in que 2.

    Best C
Reply
  • Here is a post that has some relevant information.
    forums.highend.com/showthread.php?t=11647&highlight=sync+DL3

    Do your fixtures have different fixture id's?

    Having a setup que as described has always been helpful in keeping fixtures in sync.
    My menthod is tho have the relevant layers at 0 intentsity,and rewound in the mode settings in que 1 and then loop forward at full intensity in que 2.

    Best C
Children
No Data