DL-3F: proj comm error

Projector answers to remout control, so it is alive. Physical connectors are secured.
DL-3 answers to HOG4 commands, even shows content to built in display, but not via Proj.
What can be a source of the ERROR?
P.S. rebooting, reset to factory defaults - have no effect.
I could start a show with this error after manual powering projector by remote control, but projector doesn't power up via DMX command.

0 deleted HES user - Former HES Forum Member over 10 years ago

Hi,

Does the fixture work when you put it into Video Self-Test?

In addition to Factory Defaults, have you also run Projector Defaults, on SET > PROJECTOR? This take about 2-4 mins, and there is no status. Just select the option and allow the fixture to sit idle for a few mins.

Hope this helps,
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 alloalex - Former HES Forum Member over 10 years ago

Thanks a lot for the immediate response!

--Self-video doesn't play, untill l manually power proj. On.

--I pushed Reset on the backside of the proj., after powering it by separate power cord and turning it on by remote control. Reset was done, but proj. Led still flashing...

Tomorrow i will make it more intelligent way - via menu, as you just suggested :-)

So, i will post the results here.
Thank you again!
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 alloalex - Former HES Forum Member over 10 years ago

:hogsign:

OK - now error dissapears!

1. Local menu on the Front panel of DL-3:

>SET>PROJECTOR>reset

>SET>FIXTURE>FACTORY DEFAULTS>ON

2. Power off.

3. POWER ON.

>SET>FIXTURE>FACTORY DEFAULTS>OFF

_________________________________________
Thanks a lot, Mr. p_hancock - it was the best Xmas present :friday:
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel