ColorSource Par and Spot Setting

Hello. I have a system in which there are three rows of fixtures (mixtures of CS Pars and CS Spots) coming off of a DMX splitter. When the fixtures loose DMX (when the ColorSource AV console is turned off), one row of lights goes to full brightness. This only occurs on one row of fixtures. Any idea what may be causing this?

Thanks!

Parents

ueliriegg over 5 years ago

those fixtures seem to have a preset recorded. you can delete it with the Concert software. concert talking to those fixtures however relies on RDM, so if your DMX splitter is not RDM capable you will have to connect them directly to a ETC Net3 gateway (network to DMX translator).

if you can get to fixtures you can also record empty presets over the current presets. there is a section about recording presets in the installtion guide: https://www.etcconnect.com/WorkArea/DownloadAsset.aspx?id=10737494635
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

ueliriegg over 5 years ago

those fixtures seem to have a preset recorded. you can delete it with the Concert software. concert talking to those fixtures however relies on RDM, so if your DMX splitter is not RDM capable you will have to connect them directly to a ETC Net3 gateway (network to DMX translator).

if you can get to fixtures you can also record empty presets over the current presets. there is a section about recording presets in the installtion guide: https://www.etcconnect.com/WorkArea/DownloadAsset.aspx?id=10737494635
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

jdonegan over 5 years ago in reply to ueliriegg

Thank you for the info. It does sound like preset 1 may be active in the background. I will check it out. Thanks again.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel