• State Not Answered
  • Date
    Steve Martin
  • Date
  • Replies 1 reply
  • Subscribers 14 subscribers
  • Views 4656 views
  • Users 0 members are here

Can the Source 4WRD use plastic gobos?

I was wondering, is possible to use plastic gobos (made from printable overhead sheets) in a Source 4 with the Source 4WRD attached as you can on the Source 4 LED Lustr 2?

Parents
  • 0
    We have performed some initial tests with various patterns for up to 2 hours with only minimal warpage of the film. Individual experiences may vary depending on the density of the pattern. We have seen a heavy black printed film warp and begin to smoke. I would suggest keeping the printing under 50% of the area, and orient the printed side away from the LED source.
Reply
  • 0
    We have performed some initial tests with various patterns for up to 2 hours with only minimal warpage of the film. Individual experiences may vary depending on the density of the pattern. We have seen a heavy black printed film warp and begin to smoke. I would suggest keeping the printing under 50% of the area, and orient the printed side away from the LED source.
Children
No Data
Related

www.etcconnect.com