well I am having a problem with one of my axon, it runs for about 5-8 m then freezes and cut off signal to the projector also the amber light goes off: any tips:):(
I would start by re-imaging your servers to image v3.2.0 (software v1.5.0 b2009 and XPe 3.0.0) as 1.3.x software is several years out of date at this point (1.3.3 was released in May 2007).
Prior to upgrading, backup any custom content on an external drive or USB stick just in case.
YOU MUST DO THE FULL INSTALL TO UPGRADE! You cannot use the smaller upgrade package for this.
Any CMA computers youuse should also be upgraded to v1.5.0
you can download here:
www.flyingpig.com/phpscripts/recovery.php
You will need you server's serial ##s to download.
I would start by re-imaging your servers to image v3.2.0 (software v1.5.0 b2009 and XPe 3.0.0) as 1.3.x software is several years out of date at this point (1.3.3 was released in May 2007).
Prior to upgrading, backup any custom content on an external drive or USB stick just in case.
YOU MUST DO THE FULL INSTALL TO UPGRADE! You cannot use the smaller upgrade package for this.
Any CMA computers youuse should also be upgraded to v1.5.0
you can download here:
www.flyingpig.com/phpscripts/recovery.php
You will need you server's serial ##s to download.
