• Date
    texas4485
  • Date
  • Replies 1 reply
  • Subscribers 66 subscribers
  • Views 2624 views
  • Users 0 members are here

How to set Panic to HTP?

I have 3 SR48 and 1 SR12 All networked together. My house light control in the house is a Panic switch. MY CEM+ have version 3.1.0, just upgraded from 2.0. If Panic is activated the house is up and I have control of all other dimmers. Which is great. However when I bring the House dimmers up via DMX and press the Panic to deactivate, it fades the house lights completely off before allowing DMX to regain control. It does not bump out and fade up upon activation, just deactivation. This is new to me as the previous version worked as HTP. ANy help would be great. I would like to make both HTP.

Parents

  • Hi texas4485,

    Can you please give us a call at 800-688-4116 on M-F between 8-5 CDT when you have some time to discuss this? There are a multitude of reasons that you could be seeing this behaviour and it will be easier to narrow down over the phone. This way we can also get some more information about your specific installation and configuration.

    Thanks,

Reply

  • Hi texas4485,

    Can you please give us a call at 800-688-4116 on M-F between 8-5 CDT when you have some time to discuss this? There are a multitude of reasons that you could be seeing this behaviour and it will be easier to narrow down over the phone. This way we can also get some more information about your specific installation and configuration.

    Thanks,

Children
No Data
Related

www.etcconnect.com