Smartpack issue

I am having an issue with a 12 circuit smartpack. I have 3 in total, one of them has 4 circuits that are constantly at full, The display shows them at 0% the controller isn't sending dmx values. What might be the issue?

Parents

0 MPenisten over 7 years ago

Which four circuits are misbehaving? Also, is the pack being fed with single-phase (2 hots) or three-phase (3 hots)? Have you already tried resetting the pack by turning power off and back on? There are a number of different things that could be going on, but answers to these questions might help narrow it down a little.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Craig Langlois over 6 years ago in reply to MPenisten

They are being fed with single phase. I have reset the packs. both by turning them off and on. and through the menu.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Craig Langlois over 6 years ago in reply to MPenisten

They are being fed with single phase. I have reset the packs. both by turning them off and on. and through the menu.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

0 Craig Langlois over 6 years ago in reply to Craig Langlois

I believe the circuits are 5 thru 8. The building has 3 12 circuit packs this is only happening on one of them.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel