ColorSource Relays

I have 8 Colorsource relays at various points in my rig. I also have ETC Net3 single port nodes. When I turn RDM on The Fixtures plugged into the relays don't power off when DMX is lost. Is this a RDM issue? How should the Nodes/ Relays be configures in Concert?

Parents

0 ueliriegg over 4 years ago

i would guess this is rather a DMX Hold issue than RDM?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Craig Langlois over 4 years ago in reply to ueliriegg

The Lights that are plugged into the relays do lose DMX when the board is shut off. I am Using ETC LED Lustr+ the DMX light is blinking
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 ueliriegg over 4 years ago in reply to Craig Langlois

could it be this?

Manual - ETC ColorSource Relay
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Craig Langlois over 4 years ago in reply to ueliriegg

I have them Set to Auto, I haven't tried the other 2 modes. I know how to change a DMX address value but How do I Send an RDM Command via macro?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Craig Langlois over 4 years ago in reply to Craig Langlois

They work fine in auto mode.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Craig Langlois over 4 years ago in reply to Craig Langlois

They work fine in auto mode.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data