Power Control Processor 4.1.0 flashing circuit work around

Since PCP 4.1.0 has no Web UI right now is there a way, out side of being at panel or setting up a show on board, to flash circuits? Don't see a way to control panels from Concert (force a relay on/off), if I want to flash the circuits to confirm where everything is wired.

Parents

0 ryan jacobsen 2020 8 months ago

If you have the panel networked you should be able to run sACN viewer on a connected laptop and transmit an sACN universe to that PCP. The channel check and fade range tabs should have the tools you need.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 ryan jacobsen 2020 8 months ago

If you have the panel networked you should be able to run sACN viewer on a connected laptop and transmit an sACN universe to that PCP. The channel check and fade range tabs should have the tools you need.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

0 jason haislet 8 months ago in reply to ryan jacobsen 2020

Thank you!!! I knew there was another program. I wasn't in front of tech computer today. I was racking my brain all day.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel