Sensor IQ, 0-10V Feature Requests

Hi all, was working on a system with 5 Sensor IQ panels, they all had 0-10V Cards installed, and many of the fixtures use 0-10V. 

Originally, the Racks were patched to a single Universe, DMX addresses straight down the panels.

I was updating the System to use different Universes and Addresses to make patching certain circuits for a touring console much easier. Though ran into a few pain points along the way I'm looking to see what others think:

1. Concert could really benefit from more of the devices being able to generate CSVs for their configurations. There were a lot of times I had a spreadsheet made with the data I wanted to assign to the breaker panels and circuits, but there is no way to get a CSV from Concert that I could then paste data into and reupload. That would have made switching the configurations easier. In general I think all devices in Concert should have this capability.

2. I ran into an issue where I was chasing my tail for a bit and didn't realize my mistake. The Web Browser displays information for each breaker, but it doesn't show the 0-10V level for each circuit. or N/A if not enabled. I didn't realize the Circuits needed to be set to the Fluorescent Mode, so when I loaded my configuration with the Breakers set to Normal, the 0-10V controller seems to have held the 0-10V value that it last had. A lot of the circuits were at 0, so they appeared to still be off, throwing me off to the problem that 0-10V wasn't working correctly. In general can we make it more visible on the UI, the web browser or concert what mode or what value the 0-10V circuits are at?

Related